RUBBER RETURN LINE METHOD
Drill a 5/16-inch hole in the sending unit plate adjacent to where the main line enters the tank. This will be the hole for your return line. Insert a
short length of 5/16-inch hard line (available at most radiator shops) into the hole and weld it to the sending unit plate. The hard line should
extend through the hole 1 to 2 inches on each side of the plate. Connect a length (at least 4 inches) of 5/16-inch rubber return line hose to the
hard line that will extend into the tank. Connect the rubber line to the fuel pickup line using tie wraps.
7
Pro-Flo EFI Installation Instructions
©2008 Edelbrock Corporation
Brochure No. 63-3527
Catalog #3527, #3528
Rev. 8/08 - AJ/mc
BULKHEAD FITTING METHOD
Drill a 9/16-inch hole in the sending unit plate adjacent to where the main line enters the tank. This will be the hole for your return line. Insert a
#6 AN bulkhead fitting (available at most radiator shops) into the hole, the narrow end of the fitting on the inside of the plate. Apply a rubber
washer or RTV sealant and fasten the fitting to the plate with the nut. Connect a length (at least 4 inches) of flexible return line (rubber or
braided hose) to the fitting end. Connect the return line to the fuel pickup line using tie wraps.
NOTE:
THIS METHOD REQUIRES NO WELDING OF THE FUEL SYSTEM.
NOTE:
Whichever method you use to install the return fuel line, be
careful to keep the end of the line away from the fuel pickup, as
shown. Otherwise, aerated return fuel can be drawn into the pickup.
