©2004 Edelbrock Corporation
Rev. 1/04 - RS/mc
Catalog #15005
Brochure #63-0245
INTAKE MANIFOLD GASKET
(For Honda D16Y8 Engines)
Catalog #15005
INSTALLATION INSTRUCTIONS
®
PLEASE
study these instructions carefully before installing your new Edelbrock Intake Manifold Gasket. If you have any
questions or problems, do not hesitate to contact our
Technical Hotline at: 1-800-416-8628,
from 7am-5pm, Monday-
Friday, Pacific Standard Time or via e-mail at:
. Please fill out and mail your warranty card.
Installation Procedure
KIT CONTENTS
Qty.
Description
1
Intake Manifold Gasket
•
Description:
This is a replacement intake manifold gasket, which is supplied in the catalog #1500 turbo kit, as well as
the intake manifold kits, #4754 & #4756.
Edelbrock Corporation
2700 California St.
Torrance, CA 90503
Tech Line: 1-800-416-8628
Office: (310) 781-2222
E-Mail: [email protected]
1. Remove the intake manifold as shown in your instructions for part #1500, #4754, or #4756.
2. Clean all gasket mating surfaces. Stuff paper towels into the open intake ports before cleaning to prevent any debris from
entering the engine.
3. Re-install the intake manifold as shown in the #1500 or #4756 instructions, using the new gasket. If your vehicle was not
equipped with air injection, trim the top edge of the gasket
(See. Fig. 1)
.
4. Torque all intake manifold bolts to 17 ft/lbs., following the sequence below
(See Fig. 2)
.
1
7
4
3
5
2
Torque all bolts to 17 ft./lbs
6
Fig. 2
Fig. 1
Cut along dashed lines
