TriTrax™ 200 Vertical Crawler
Document: UMDT017749.docm
Revision: A02
Created by: JS
Date: 13 Apr 2021
IPN: 3094329-A02
Source Location: C:\ePDM\ISLEng\Products\DT-VersaTrax100MkII\Manuals\UMDT017749.docm
Page 34 of 36
User Ma
nual
Force Feedback Calibration
1. Drive the expansion mechanism somewhere in the middle of its travel.
2. With no load on the spring link, Set
MIN
in ICON.
3. Set
MAX,
in ICON when there is no load on the spring link.
4. Push down the linkage and fully
compress the spring
, Set
MAX
in ICON.
IMPORTANT:
Always double check your calibration after completion.
Note: Force and diameter feedback are included for operator situational awareness only and are never
intended to provide accurate measurements.
