Eddyfi Technologies TSC U41, User Manual

Page: 42 / 72

Assist3 Software
30 | www.eddyfi.com
General
Figure 4-1
Backstage view: General
Job Details
To configure a job, values for Site, Component and Operator name should be entered here.
x x
Site
refers to the site or location where the inspection is carried out. This may also be a job
or workpack reference.
x x
Component
may refer to a larger structure or assembly that has multiple inspection areas,
such as a vessel, line, tank or vehicle. These names will be used in following inspections.
x x
Part ID could be a subcomponent name or weld ID which would identify the specific
location of a series of inspection scans.
Your work is automatically saved so there is no need to create files and folders. Instead, the
system will use these labels to automatically create files and folder names for you. For this
reason, it is worth entering these labels in a full and formal manner. The operator’s name will
be appended to any reports which are automatically generated by the system, so it’s best to
use your full name.