Versatrax 150™
Document: UMDW014058.docm
Revision: A03
Created by: KW
Date: 10 Oct 2019
3075415-A03
Source Location: C:\ePDM\ISLEng\products\dw-versatrax150mkii\manuals\UMDW014058.docm
Page 22 of 57
User Ma
nual
Manual Camera Height Adjustment
If the Versatrax 150™ has a manually adjustable camera bed the height of the camera may be adjusted
as follows:
1. Remove the push button locking pin.
2. Adjust the height of the camera to the nearest locking hole.
3. Re-insert the locking pin.
Note that there are two columns of numbers on the indicator plate. STD is for the standard
chassis setup, while XT is for when the track extension plates are installed.
Minimum Bend Sizes
As the vehicle fits into smaller pipe sizes, the
minimum bend radius it can navigate becomes
restricted. The following table lists the minimum
bend radius for different sizes of pipe based on
a 90-degree bend, internal pipe diameters, and
the standard parallel chassis configuration.
Pipe ID
Bend Radius to
Centerline
305 mm (12 in)
Straight
355 mm (14 in)
5D
– 1,780 mm (70 in)
405 mm (16 in)
3D
– 1,220 mm (48 in)
455 mm (18 in)
1.5D
– 685 mm (27 in)
510 mm (20 in)
1D
– 510 mm (20 in)
