Versatrax 100™
Document: UMDT013103.docm
Revision: A10
Created by: KJB
Date: 26 Sep 2019
3070984-A10
Source Location: C:\ePDM\ISLEng\products\dt-versatrax100mkii\manuals\UMDT013103.docm
Page 37 of 41
Us
er
M
an
u
al
Connector Care
Proper connector care is important for system reliability. Preventable connector problems can represent a
significant cost in downtime and re-termination which could easily have been avoided
. A good tether isn’t
much use without a connector. We recommend the following steps to help prevent damage to connectors.
1. When plugging in a connector:
a. Ensure the system power is OFF.
b. Inspect for dirt in both sides of the connectors.
c. Inspect for bent or burnt pins.
d. All connectors - visually align the key-way or locating pin first before plugging in. Do not blindly
jam and twist.
e. Fully tighten or engage a connector. Never use a connector partly plugged or screwed in.
Contacts left partly open may be subject to leaking, arcing or burn-out. In general, locking collars
need only be finger tight.
2. Do not plug in dirty or damaged connectors.
3. Cap any unused connectors with dummy plugs.
4. The rubber vehicle and camera connectors are wet pluggable. The small collared light and track
connectors must be dry when mating.
5. The waterproof vehicle connectors require occasional lubrication:
a. Wet pluggable connectors, including the vehicle and camera connections, should be lubricated
with silicone grease.
b. Dry mating miniature connectors on the Microtracs and 801 lights can be lubricated with 3M
Silicone Spray (or equivalent). Do not grease these connections.
6. Never use WD-40 or similar solvent-based fluids as this can cause serious damage to connectors.