Versatrax 100™
Document: UMDT013103.docm
Revision: A10
Created by: KJB
Date: 26 Sep 2019
3070984-A10
Source Location: C:\ePDM\ISLEng\products\dt-versatrax100mkii\manuals\UMDT013103.docm
Page 16 of 41
Us
er
M
an
u
al
Vehicle Configuration
Parallel Configuration
Track Angle Adjustment
The parallel chassis’ track angle may be continually adjusted from flat to 8-inch [200mm] pipe. To change
the track angle, loosen the four M6 socket cap screws located in the end plate slots, move the track to its
new angle, and retighten the screw. Indicator marks have been placed o
n the end plates for 8”, 10”, 12”,
24” and FLAT configurations (200, 250, 300, 600 mm).
FIGURE 6: TRACK ANGLE ADJUSTMENT