Spectrum 45™ Camera
Document: UMAA007219.docm
Revision: A14
Created by: PV
Date: 08 Dec 2019
IPN: 3041015-A14
Source Location: C:\ePDM\ISLEng\products\aa-spectrum45\manuals\UMAA007219.docm
Page 11 of 16
User Ma
nual
Operation
Pre-Operations Check
A Pre-Operations check should to be carried out prior to every camera mission.
1. Visually inspect the camera to ensure that there is nothing jamming the movement.
2. Check the camera cable for cuts, tears, etc.
3. Check that the camera connector is fully engaged and that the locking collar is finger tight.
4. Ensure that all other cables are properly connected including the monitor.
5. Clean the camera port (window).
6. Power up and test all camera functions. This includes adjustability of the lights and
full
pan and
tilt movements.
7. Verify the functionality of your monitor and video recording equipment. At this time verify the
functionality of the video overlay, zoom and manual focus settings.
Post-Operations Check
A Post-Ops inspection should be carried out after every camera mission.
1. The system should be visually inspected for mechanical damage.
2. If the system has been used in salt water, thoroughly rinse the camera and pole with fresh water
right away. Accelerated corrosion will result if the camera is not rinsed properly. Pay close
attention to rinsing and cleaning the spaces between moving parts.
CAUTION:
Do not use a pressure washer to clean the camera. Very high-
pressure water can push past seals and flood the camera resulting in electrical
damage or personal injuries.
3. Clean off the camera and remove objects or debris from between its moving parts.
4. Visually check through the camera port to ensure that no water has entered the camera.
5. Inspect the camera cable for cuts, nicks or kinks. Store the camera in its rugged case with the
connector sufficiently protected.
ICON™ & ICON™ RPT
Camera control and video recording are accomplished using ICON graphical interface controller software.
Video playback and reporting are conducted through ICON RPT.
Manuals for these two software
packages are included separately.
Controls for recording and snapshot functions are kept on-screen
with the camera controls.
•
ICON Manual
– (Control Interface and Recording)
•
ICON RPT Manual - (Reporting, Playback and Video Export)