ECTACO Partner
®
ES B-3
User Manual
7
out of the holes. We recommend that you keep the cover attached when you are
not using your ECTACO Partner
®
ES B-3.
Power Supply
ECTACO Partner
®
ES B-3 is powered by two AAA (LR03) batteries. Please insert
the batteries before connecting your device to a PC. Use the universal indicator to
check the current condition of the batteries (see page 11). Replace the batteries
when the indicator runs low.
♦
Note:
If the battery power runs too low, the unit will start up when you press the
On/Off button but will then shut off automatically. When this happens, please
replace the batteries immediately to avoid the risk of losing user data.
How to replace the batteries
•
Press the On/Off button to turn the device off.
•
Make sure the device is not on a hard surface – if the On/Off button is pressed
accidentally, user data may be lost.
♦
Note:
To avoid data loss,
never try to remove the batteries from the device
when the power is on
. If you experience difficulties turning the device off,
press the RESET button on the back of the device and restart the system.
•
Remove the battery compartment cover by sliding it away from the device.
•
Remove the used batteries and replace them with new ones.
♦
Note:
Do not mix old and new batteries.
•
Make sure to place the batteries according to the polarity marks (+ -) inside the
battery compartment.
•
Put back the battery compartment cover by sliding it toward the device. Make
sure the cover sits in place properly.
♦
Note:
You have one minute to replace the batteries without risk of losing the
data stored in RAM.
Do not exceed the one-minute limit!
Neither the
manufacturer nor the dealer may be held responsible for the loss of user data.
MultiMedia Card
ECTACO Partner
®
ES B-3 MultiMedia Card is included in the standard package.
The card contains the operating system and a set of applications described in the
Applications chapter (see page 17).
