ECRM Mako 8 CTP, Operator'S Manual, Page: 14 / 56

8 AG114123 Rev. 2
Power Switch
The power switch controls ac power to the system. To start up the
system, turn on the power switch located on the rear right side of the
machine. Depress zero (0) to turn
OFF ,
depress one (1) to turn
ON
.
See Figure 2-2.
Note: It is recommended that the system be powered on for a 1-
hour warm-up period prior to imaging.
Pin Bar
The pin bar is used for plate registration. There are two types of pin
bars: press notch registered and edge registered.
Up to two pin bars come with the system as standard equipment.
Additional pin bars can be ordered as an option. Exposing sets of
plates with different registration notch requirements is easily
accomplished by changing the pin bar.
Control Panel
The control panel allows you to interact with the platesetter.
Commands and menu selections are controlled through this device.
Input Tray
The input tray is used to position the plate for exposing. The plate is
placed on the input tray and gently pushed against the registration
pins.
A new plate cannot be loaded until the previous plate has been
completed.
Media Transport
The media transport provides for automated delivery of media to a
customer-supplied online processor.