28
On
(steady): indicates connected to Wi-Fi network; network
communication normal and data uploaded to configured weather
service(s) successfully.
Off
(steady): Wi-Fi connection failed.
Flash
(slowly), indicates connected to Wi-Fi network; network
communication normal, but upload to one or more configured weather
services failed. First confirm Internet access through your router is
functioning, and then check whether the upload server account and
password are correct (use WS View application).
Flash
(rapidly), indicates that Wi-Fi configuration mode is active. Use
the WS View mobile application to complete the configuration.
4.6.2
Button functions
The black button is used for the following two modes:
Wi-Fi Configure Mode:
Press and hold the button for about 5 seconds until
the Wi-Fi status LED is flashing rapidly, indicating the gateway is ready for
Wi-Fi configuration.
Reset Mode:
Hold the black button for about 10 seconds till the red
light and blue light flash simultaneously for three times will reset the
gateway to factory settings. The history data, Wi-Fi settings, calibration etc.
are all lost and need to be setup again via WS View app.
Note:
1.
When powered up, and when there is no valid Wi-Fi configuration (including
very first time), the Wi-Fi status LED will be rapidly flashing. It means that
the gateway is in the Wi-Fi configuration mode. Use the mobile application to
complete the configuration process.
2.
If you purchased optional sensor(s), you may power up the new sensor
at any time and use mobile application’s live data view to confirm
whether the sensor has been added successfully. If this does not appear
the case, also check the
Sensors ID
page to see if the sensor’s ID has
been registered.
Summary of Contents for GW1002
Page 38: ...38 Dashboard Graph display ...
Page 39: ...39 List display Weather Map ...
