5
BEFORE USING WATER FROM YOUR WATER PURIFIER FOR THE FIRST TIME
continued from page 4
12. Steam will continue to pass through for a few
minutes. After unit cools, rinse out kettle.
13. Shake the carafe, then discard the first batch of
water which may have some harmless carbon
fines (very fine black particles) in it from the
filter.
MAKING PURIFIED WATER
1.
Set the Purifier on your countertop or table.
2.
Unplug the kettle from the base (Figure 1).
Twist the cover counter-clockwise to remove,
and set aside.
3.
Rinse and fill the kettle with tap water up to the
max. fill line.
NOTE: You can purify less than the full amount. Use
this chart as a guide. DO NOT fill the kettle over the
max. fill line because the carafe will overflow.
WHEN YOU FILL WITH
TAP WATER TO...
THE CYCLE
TAKES
ABOUT...
Model EWS-US500/12O (3 qt.)
Model EWS-US800/120 (1 gallon)
5 hours
4 hours
4.
Replace the cover on the kettle. Twist cover
clockwise to lock. Plug the kettle into the base
unit. Carry carefully and keep level to prevent
splashing.
5.
Set the carafe into place on base unit.
6.
Plug the power cord into any 120 volt outlet.
7.
Press the reset or start button. The red indica-
tor light will illuminate.
When the cycle is over the Purifier turns off automatical-
ly. AFTER THE FAN MOTOR GOES OFF, WAIT AT
LEAST 30 MINUTES BEFORE REMOVING THE
COVER...
WARNING: NEVER REMOVE THE COVER WHILE
THE FAN MOTOR IS RUNNING, OR FOR 30 MIN-
UTES AFTER IT STOPS. YOU COULD GET SE-
VERE BURNS FROM THE BOILING WATER OR
STEAM.
8.
To pour water from carafe, open spout by pull-
ing on center strip in direction of the arrow indi-
cator near thumb position.
9.
Store the carafe filled with product water in the
refrigerator until you need it.
10. After the Purifier has cooled (wait for 30 min-
utes after the fan motor stops running) remove
the kettle to clean.
CARE AND CLEANING OF YOUR WATER PURIFIER
KETTLE
After each use, rinse the inside with lukewarm tap water
and remove any residue. Clean by wiping out the inside
of the kettle with a damp cloth and rinse. If a deposit
starts to form at the bottom, use Water Purifier cleaner
(see page 7). Remove the kettle from base unit. Fill
kettle at the sink with hot water and follow the instruc-
tions on the cleaner bottle. Rub with a soft scouring pad
and rinse thoroughly.
CAUTION: DO NOT IMMERSE THE PURIFIER OR
KETTLE IN WATER.
CARAFE
Clean with mild dish detergent and soft cloth. Rinse
thoroughly with water.
CLEANING EXTERIOR SURFACES
To keep your Purifier looking new, you should period-
ically clean the exterior plastic surfaces with a soft,
damp cloth. DO NOT use any caustic cleaning solu-
tions, scouring pads or powder because they will
damage the plastic finish.
NOTICE
THERE ARE NO USER SERVICEABLE PARTS
INSIDE THE UNIT.
CHANGING THE CARBON FILTER
IMPORTANT: The purifier uses a carbon filter in the ca-
rafe cover to remove traces of odors before the purified
water is collected in the carafe. The filters last about 2-3
months. A return of unwanted odor means the filter
should be replaced. Order replacement carbon filters
from the outlet where you purchased your purifier (see
page 7).
continued, page 6.
