Safety Instructions and Warranty Terms
24
Manual econ sens+
Version 1.40
In the info area, the MAC address of the device is shown at the top. Under this is listed all of the
information provided by the DHCP server, which may exist in the system. If there is no DHCP server in
the system, these info fields remain empty.
In the table below this the following settings can be made:
Which IP address should be used?
You have the choice between manual assignment of the IP address or assignment of the address by
DHCP server. The default setting is the function:
If possible obtain IP address per DHCP
.
If the device does not find a DHCP server, the data from the IP address, subnet mask, default
gateway, DNS server and network device name fields are automatically used. The data shown in Fig.
20 represents the device default settings.
The
ping IP address
field is used to send a ping command to a defined IP address, as you may be
familiar with from DOS. This function is used to test the network connection.
Electrical submenu
The Electrical submenu is used for configuration
Econ sens+ can be used in various different power systems, e.g. in 2, 3 and 4-wire power systems
with any load. The device can be operated in power systems with a nominal voltage starting at 120V
(e.g. USA), as well as in power systems with 230/400 V and 400/690 V. Different power frequencies
(50 und 60 Hz) can also be represented.
For the configuration of the power system, in which econ sens + will be used, there are only a few
settings to be made.
You can either use one of the predefined settings or compile all of the parameters yourself using the
user-defined settings.
Figure 27:
Main page of the Electrical menu
