Safety Instructions and Warranty Terms
13
Manual econ sens+
Version 1.40
Connecting the network
The econ sens+ energy consumption meter has a 100BASE-T network connection for web interface
access. This can be connected to a PC either directly or via a node such as a hub or switch. Connect
the econ sens+ to your hub/switch using a patch cable (1:1) or directly to your PC (using a crossover
cable).
Further information on the IP
address settings, etc. can be found in the “Initial operation” chapter.
Modbus TCP
Via the network connection measured values and events (Pro variant) can be accessed via the
Modbus protocol for both versions (S0/RS485). The parameter settings are performed in the Modbus /
pulses / s submenu. The corresponding register addresses can be found in the manual on page 34 ff.
Web Interface of the econ sens+
Accessing the web interface
The web interface is accessed by entering the IP address of the econ sens+ in the address bar of the
web browser (Firefox, IExplorer, GoogleChrome, etc.). The network default settings of the econ sens+
are as follows:
IP address:
192.168.0.1
Subnet mask:
255.255.255.0
Standard gateway:
192.168.0.254
For the web interface to be accessed, ensure that the user PC is in the same network as the econ
sens+. Configure as follows (e.g. under WinXP):
Figure 14:
econ sens+ network connection
