Ecom DK50, Installation, Operation And Maintenance Manual

Page: 11 / 60

DK50
04/2015 - 9 - NP-DK50 simple s DE-2_04-2015


1/N/PE ~ 230V 50Hz
ELECTRIC OBJECT OF 1st CAT.
B TYPE
N
40°C
ST1
p >
SP
1
M1
M
PE U N
EV1
B1
C
XC1
Q1
FU1
9.2. Compressed air connection
(Fig.5)
Dental compressor with a compressed air
outlet, OUT (9), located in the front of the box.
Connect pressure hose for connection to the
relevant dental device to coupling (9) –
pressurized air output.
9.3. Electrical connection
Plug the electrical cord into the mains.
The appliance is equipped with a grounded plug. Make sure this connection complies with
local electrical codes. The mains voltage and frequency must comply with the data stated
on the appliance label.
(Fig.1)

Keep the socket easily accessible to ensure that in an emergency the appliance can be safely
disconnected from the mains.

Connection to the power distribution box shall be protected with a locking element.

Connection of the ground connection (15) to other appliances must adhere to local electrical regulations.

Fasten down the electrical cord through the holder (14).

The device is protected by fuses located in the fuse housing (17) beneath the cover of the main switch.
Electrical cord may not contact the hot parts of a compressor. Insulation could be
damaged!
If any electrical cord or air hose is damaged it must be replaced immediately.
10. WIRING DIAGRAMS
M1 Motor of compressor
EV1 Fan of compressor
ST 1 Thermo switch
CB1 Capacitor
SP
Pressure switch
FU Fuses
Q1 Main
switch
XC1 Connector
Fig.5
9