WST-220 Wireless Recessed Contact
Specifications
Frequency: 433.92MHz
Operating Temperature: 32°-120°F (0°-49°C)
Battery: 3V lithium CR-2
Operating Humidity: 5-95% RH non condensing
Battery life: 5 years
Compatible with DSC 433MHz receivers
Magnet gap: 1 inch max
Supervisory signal interval: 60 min(approx.)
Enrolling
Each product has a label with a unique 6 digit serial number. You will need this serial number to
add this contact to your security system. Refer to your specific control panel or wireless receiver
installation instructions for details on adding a new contact.
Mounting
The recessed sensor and magnet are designed to fit snug in a ¾ inch hole and a small flange on the
outer rim ensures the case cannot be pushed too far into a hole.
Choose a suitable location for the sensor, drill a ¾ inch by 2.5 inch hole in the door for the sensor.
Mark the location for the magnet in the frame directly in line with the sensor and drill a ¾ inch by
½ inch hole for the magnet.
Installing /Replacing the Battery
When the battery is low a signal will be sent to the control panel. To install/replace the battery:
1.
Remove the cap on the transmitter.
2.
Take note of how the circuit board fits into groves on the side of the case.
3.
Carefully slide out the circuit board.
4.
Inspect the battery holder to determine which side the battery is inserted/removed.
5.
Install /replace with a CR-2 battery ensuring the + side of the battery faces towards the
circuit board.
6.
Re-insert the circuit board so that the board slides within groves in the plastics.
7.
Once in, replace the cap.
Note:
Removing the cover will trigger a zone tamper signal to the control panel