All specifications are listed below.
Electrical power supply 230V, 50/60Hz, maximum consumption 13/20 mA.
Inputs
:
Exhaust gas temperature – Type J
Outer thermostat - contact
Probe NTC temperature room – NTC 10 k
Outputs:
Exhaust gas aspirator – 230 V
Exchanger - 230 V
Low-range gear lever – 230 V
Heater - 230 V
Room specifications:
Operative temperature – from 0 to 60
o
C
Storage temperature – from -10 to 60
o
C
Maximum relative humidity – 95%
Mechanical specifications:
Dimensions 125 x 101 x 35 mm
Weight 250 gr
Connectors
:
4.4
INSTALLATION
All required cables and connectors are put into the pellet stove. The installation is quick and simple.
Before each assembling of the system, an automatic test of the system is performed for its proper operation.
When you turn on the product for the first time, you should do the following:
When you are sure that the assembly is properly done, it is possible to start initial turning on the pellet stove, which
will allow its proper setting. The setting might be made either through the control panel or the software.
For normal operation of the stove, it should be changed some parameters depend on the installation of the stove,
different type pellet, length of the chimney etc… For that purpose, we explain which parameter what it means so you
can easy understand how the stove works. To enter in parameters follow these steps:
Push the "arrow" button so you go to "settings" menu (gear icon) last right on the display. Should be on position
"OFF", then with the "+" go to menu 9 for the AIR models or 8 for the WATER models and here you can get the code
pressing "set" (enter) to continue to the service parameters of the menu. The code is the sum of the 4 digits of the
number that appears on menu 8 (or 9) plus 1. You will enter it with the button "+" (when you push on display counts
1,2,3,4….up to the number of the code), then push again "set" (enter) and you are in the service settings menu. You
have to press "+" until you go to menu "par" press again "set" (enter). Now you are in the service menu of the stove
choose the menu settings number push "set" (enter) and you can change the parameters of the stove. Check the
table..
