Eco-King HWB-299, Installation And Service Manual

Page: 71 / 124

E93.1801EN171 HWB installation manual 71
Screens and settings.
This screen is active during power up and will remain active until communication with the Main Control (the AL-
BUS) has been established.
After communication has been established the following
Status overview appears:
13.2.1 S
ET
A
CTUAL SETPOINT
/DHW
SETPOINT DIRECTLY VIA THE
S
TATUS OVERVIEW
You can adjust the DHW setpoint directly on the bottom of the Status overview.
Press UP/DOWN
↑↓
to select the mode, then press CONFIRM or RIGHT
→
to confirm the mode and the
Actual/DHW setpoint becomes directly settable. Use UP
↑
or DOWN
↓
to increase/decrease the setpoint.
Press CONFIRM or RIGHT
→
to confirm your alteration or press ESC or LEFT
←
to cancel.
A setpoint is only visible on the display when no error or alert is active. In case of an active error or alert, the bottom
right part of the display is used to display the error or alert text.
13.2.2 E
NTERING THE MENU
Enter the menu by pressing the MENU button once. The header in the display shows you are inside the main
menu. While scrolling through the menu you will see that the selected menu item is shown in a white rectangle.
Enter a menu item by pressing CONFIRM or RIGHT
→
.
The header shows your location inside the menu, as seen in the following image:
Use “DHW Setpoint in case of a single water heater with one tank.
Use “DHW Store Setpoint” in case of a cascaded system with multiple water heaters and/or tanks
If you are inside the menu (or a menu item) and want to return directly to the Status overview press
MENU or ESC If you want to go back one step in the menu press BACK/LEFT
←
.
70 °F
59 °F
DHW Control Enabled






 

