183
F
or refe
re
nc
e
Before asking for repairs
Slight differences in operation can sometimes be mistaken for mulfunctions, so check the
following table before requesting any repairs.
If the following fail to solve the problem, contact your local retailer.
Symptom
Possible reason
Corrective action
The map does not move even
when driving.
Is the display showing a screen
other than the present location
screen?
Display the present location
screen. (See page 28)
The
vehicle position mark does
not appear.
Is the display showing a screen
other than the present location
screen?
Display the present location
screen. (See page 28)
The GPS mark does not appear.
Is the device in a situation where
GPS data cannot be utilized?
Move the vehicle to an area free of
obstructions or remove any objects
placed on the GPS antenna.
Voice guidance not outputted.
Is the "Auto voice guidance" set to
?
Touch
for "Auto voice
guidance" in setup.
Is the guidance paused?
If the route guidance is paused,
resume guidance. (See page 113)
Is the guidance volume turned
down (voice OFF)?
Turn up the volume. (See page 27)
Small blemishes or luminescent
spots on the monitor screen.
This phenomenon is characteristic
of liquid crystal panels.The liquid
crystal panel is make with high-tech
precision and has 99.99% or more
effective imaging. However, there
may be 0.01% image loss or lights
continuously turned on.
This is not a defect, so please use
the deck in this condition.
For a moment after turning the
engine switch ON, there is an
irregular display on the screen.
In cold weather, the liquid crystal
panel's backlight features may emit
light unevenly.
This condition stops in a few
minutes as the backlight warms up.
The screen is difficult to view.
Are the contrast and brightness
correctly adjusted?
Adjust the contrast and brightness.
(See page 22)
The
vehicle position mark
appears on a spot different from
the present location.(The
vehicle position mark is
misaligned.)
The
vehicle position mark may
be misaligned depending on
satellite conditions or vehicle status
(road conditions and driving
style).Also, the
vehicle position
mark may be misaligned if driving
on a newly constructed road or on
a road with a shape different to that
recorded in the map data.
Continue driving and the present
location will be automatically
corrected using map matching and
GPS data.(In some cases, this may
take several minutes.) If GPS data
is not used and the present location
is not automatically corrected, stop
the vehicle in a safe area and
correct the present location. (See
page 169)
There is distortion or noise on the
map screen
Is a device that generates electrical
interference being used near the
unit?
Example of devices that emit high
voltage:
Ionizers
Example of devices that emit
electrical noise:
Cell phones or other wireless
devices
Keep such devices as far away as
possible from the unit. If a device
continues to cause interference,
refrain from using it.
Off
On
Summary of Contents for AVN 5495
