INMANUUIN121 M. USO VI340-HC118G2 ING USA V.2016.10.06.DOCX 9
5. REVISION AND OPERATION
5.1 Revision
Once the installation is complete and before turning on the PROCAM HD camera we recommend to do the following controls:
•
Verify that the electrical circuit is connected to ground and in perfect condition and that the connection to the equipment is done perfectly
too.
•
Confirm that the power supply fuses are in the socket and that it is suitable.
•
Make sure no water or liquid supplies, or gases or inflammable fumes in the environment are near the equipment that can harm it.
•
The equipment has to be connected to the electrical socket through the power cable supplied by ECLERIS.
•
The electrical supply has to be done at electrical socket without power adapters.
The equipment must be used only in places where the electrical installation complies with local regulations.
If any abnormality is detected before turning on the equipment, please contact the technical service of your local distributor or
your nearest ECLERIS office before using it
5.2 Operation
In this section there are detailed procedures to turning on and verifying the equipment functions. We recommended following them after the
installation.
Only medical, paramedical or health personnel should work this equipment
1.
Press the power button in front of the PROCAM HD console. The LEDs of the PROCAM HD camera will blink for few seconds and then they