USER MANUAL
– EVERLUX
Page
6
de
11
INMANUUIN167 Rev.2019.04.01 / ENG
3.4 COMPONENTS
EVERLUX light source includes the following components. It is recommended to identify and
check their existence before proceeding with the installation.
Main Unit
Power Supply Cable
User’s Manual
4. INSTALLATION AND SET UP
Experienced or expert personnel are not required to install the EVERLUX.
Once the installation is over, please continue with the procedures detailed in the Revision
section.
Thoroughly follow the instructions included in this section.
1) Unpack the equipment carefully.
2) In case of using the EVERLUX as an endoscopic light source, place it on a solid and flat
surface.
3) Rotate the universal adapter until the corresponding connector is aligned with the light
output.
4) Connect the fiber optic cable to the corresponding connector of the universal adapter
(depending on the fiber optic to be used). The fiber optic connector shall match perfectly
and not exceed the adapter.
5) In case of using the EVERLUX as a Microscope / Colposcope light source, mount the
EVERLUX on the Ecleris Microscope / Colposcope forearm (See “Light Source
Installation” Section in Ecleris Microscope /Colposcope User’s Manual)
6) Rotate the universal adapter until the Wolf connector is aligned with the light output.
7) Connect the fiber optic cable to the Wolf connector of the universal adapter. The fiber optic
connector shall match perfectly and not exceed the adapter.
When turning the light source on, check fans functioning.
If due to any breakdown they do not work, turn the equipment off immediately to avoid
failures in the LED system as a result of high temperature.
The EVERLUX shall only be used in places with electrical installations that meet the local
regulations in effect.
It shall always be connected to the grounding of the operating room or endoscopy tower
through a ground cable.
The EVERLUX shall be connected to the voltage line through the power supply cable
provided.
The power supply shall only be provided with a protected plug and the adequate ground
connection.
