Ecleris EVERLUX User Manual Download Page 4

USER MANUAL 

– EVERLUX 

 

Page 

4

 de 

11

 

INMANUUIN167 Rev.2019.04.01 / ENG 

  Do  not  use  volatile  substances  (benzine,  thinner  or  solvents  in  general)  to  clean  the 

equipment since it may be damaged. It is recommended to use a soft wet cloth soaked in 
neutral soap or any specific product to clean electronic equipment cabinets. 

  Do not introduce objects in the holes. 

  Prevent  the  power  supply  cable  from  being  walked  over  or  placed  under  any  piece  of 

furniture. 

  Do not use the device during thunderstorms. 

  After the use of the device, turn it off and disconnect the power cable. 

  In  order  to  avoid  Electrical  shocks  this  system  must  be  connected  to  a  power  grid  with 

proper ground connection. (No exceptions) 

  The  device  is  provided  with  a  connectable  power  cable  that  assures  proper  electrical 

isolation on the grid.  

  In  the  case  of  electromagnetic  interference  between  medical  device  and  other  electrical 

device, we recommend to increase the distance between the systems in order to minimize 
the interference effects. 

  Do  not  open  the  device.  The  diagnose,  service  and  repairs  must  be  perfomed  by 

ECLEIRS,  or  a  company  authorized  by  ECLERIS.    ECLERIS  will  not  be  liable  for  the 
damage caused by repairs, or service performed by not authorize personnel. 

  In  case  of  any  problem,  the  system  must  be  laid  a  plane  surface  and  power  cable 

disconnected. 

  The device must be used only by personnel informed of all this warnings. 

  Any  use  outside  of  the  manufacturer  specific  intent  use,  will  exclude  ECLERIS  of  all 

liability. 

  This user manual must be with the device for permanent review. If the system  is sold or 

donated, the user manual must be deliver with the device. 

If as a consequence of: 

  Inadequate use of the equipment. 

  No use of this manual. 

  Poor care and maintenance of the equipment or. 

  Repair and manipulation by unauthorized personnel. 

…any material or personal damage were caused to third parties, ECLERIS, the manufacturer and 
the supplier of the equipment, shall not assume any responsibility for such damages 

Do  not  dispose  the  device,  or  any  of  the accessories with  the  domestic  waste. 
Research the local rules and laws for proper disposal. It is the user responsibility to 
deliver  the  system  to  the  proper  location  for  disposal  or  recycle  of  electrical  and 
electronic device or contact the manufacturer or authorized representative to proceed 
on the elimination of the system on a safe and ecological way. 

3.  DESCRIPTION 

3.1 INTENDED USE 

Everlux  light  source  has  been  designed  to  be  used  in  all  Ecleris  microscope  and  colposcope 
models as well as in therapeutic and diagnostic procedures. 

The cold and white light of this equipment enhances the real brightness and colors allowin its use 
for all types of procedures. 

Summary of Contents for EVERLUX












Reviews: