10
BUTTON CONTROL
8.1 Source Switching
1)
Press the
SOURCE AUTO
button to switch to next source device, and then the
corresponding input LED will turn green.
2)
Press and hold the
SOURCE AUTO
button at least 3 seconds to enable auto
switching mode. For auto switching mode, remember the following rules:
•
The switcher will switch to the first available active input starting at HDMI IN 1>
HDMI IN 2 > USB-C.
•
New input: Once a new input signal detected, the switcher will automatically switch
to this new signal.
•
Source removed: When an active source is removed, the switcher will switch to the
first available active input starting at HDMI IN 1.
•
Reboot: The switcher can save the last configuration before losing power. If the last
switching mode is auto switching, the switcher will automatically enter auto
switching mode once rebooted, then detect all inputs and memorize their
connection status for future rebooting using. If the last selected input source is still
available, the switcher will switch to this input. Otherwise, it will switch to the first
available active input source starting at HDMI IN 1.
•
Exit auto switching mode: Press and hold the
SOURCE AUTO
button for 3 seconds
to exit the auto mode, and the input source will not be changed.
8.2 Display Control
1)
Press the blue-backlight
DISPLAY ON/OFF
button to turn on/off the display by
automatically sending CEC and RS-232 command (Programming required). When
sending the ON command, the button will turn blue; when sending the OFF
command and the button will be not illuminated.
2)
The
DISPLAY ON/OFF
button also can be programmed by IR learning feature or RS-
232 command. For more details, please refer to
