Ecler VEO-XTI1CG2, User Manual

Page: 26 / 34

26
T.O.C
.
PRE
CAUTI
O
N
S
PACK
AGE
CO
N
TE
N
TS
DE
SC
RIP
TIO
N
&
FEATUR
ES
IN
ST
ALL
&
CO
N
N
EC
T
ST
ART
-UP
&
O
PE
RATI
O
N
PANE
L
FUN
CT
IO
N
S
TE
CH
N
IC
AL
DATA
6.2 VEO-XRI1CG2 (RX, RECEIVER)
6.2.1 FRONT PANEL
1. POWER LED : The LED flashes when the device is power supplied and stays lid
(RED) after the start up is complete.
2. LINK LED : Network connection status LED:
o
Light on : Network connection is stable and there’s a compatible video signal.
o
Light off : No network connection.
o
Light flashing (slow) : Ne twork connection is stable but there’s no video signal.
o
Light flashing (fast) : Network connection is stable but there’s no compatible
video signal (resolution or frame rate are greater than native).
3. STATUS DISPLAY : indicates current ID channel and further device information.
When clicking the “ SHOW ME ” option on the XCTRLG2, the status display will flash
“SHO” for an easier location of the corresponding device. For further details, refer to
Additional functionalities of CH select
▲
/
▼
buttons for both: VEO-XTI1CG2 & VEO-
XRI1CG2 chapter.
4. CH SELECT (
▲
UP/
▼
DOWN) : Use these buttons to set the ID channel of the device.
It is also possible to adjust audio mode, manage EDID, consult IP address, or enter
configuration mode
. For further details, refer to Additional functionalities of CH
select
▲
/
▼
buttons for both: VEO-XTI1CG2 & VEO-XRI1CG2 chapter.
5. RESET : System reset button. Pressing and holding for 5 seconds will restart and
restore factory settings on the device.