7
7.
CONNECTION AND INSTALLATION
1.
Connect HDMI signal source (such as PC, Blu-ray player, etc) to HDMI input of
VEO-XPS15.
2.
Connect Cat5e/6/7 cable from RJ45 output of TX to RJ45 input of RX. Shielded
cables with shielded RJ45 connectors are strongly recommended.
3.
Check the EQ switcher settings, according to the cable length, as reported in the
following table:
4.
Connect HDMI display device (Full HD display) to HDMI output of VEO-XPS15.
5.
Connect IR Blaster cable into IR-Out port of the Transmitter; Connect IR Receiver
cable into IR-In port of the Receiver.
6.
Connect 5V DC power supply to VEO-XPS15 Transmitter.
7.
If you notice any flickering or blinking on the display, adjust the EQ switch to
improve cable skew.
