Ecler IC6CLASS54X, User Manual

Page: 6 / 13

6
6. LOCATION, ASSEMBLY AND CONNECTIONS
For proper product installation, circular holes have to be made in selected places and the
appropriate wiring has to be prepared for each unit.
Here are the steps to follow for proper installation:
1. Make the mounting hole in the drop ceiling, after marking its outline with the
supplied cutting template
2. Remove the connection box using a slight pressure on the back can of the
speaker.
3. Pierce the rubber grommet of the connection box, passing the end of the
speaker connection cable through.
4. Strip the two wires of the speaker cable end and connect them to a screw
terminal inside the connection box, respecting the polarity between the speaker
(IN + and -), the other speakers of the system and the amplifier feeding them.
Note:
there are two grommets and two connectors inside the connection box,
connected in parallel to link another speaker if necessary.
5. Reinsert the connection box into the back can of the speaker.
6. Insert the speaker's frame into the hole, taking care that the 3 revolving fasteners
remain in the retracted position
7. Tighten each of the 3 screws accessible from the front of the unit. The revolving
fasteners rotate and at the end of the tightening, the frame is fixed at its final
position