12
7.2. Device Configuration menu
This menu allows adjusting the following parameters of the unit:
Device Name:
name of the device, as seen from other WPNETTOUCH /
WPmSCREEN devices, as well as from the EclerNet Manager application
Device Password:
password for the protection of the device against the editing
of its critical configuration parameters, requested for this purpose if enabled
(enabled = other than blank password)
Enable UCP Server:
enables/disables the embedded UCP server service of the
unit
o
Enabled:
the EclerNet project stored in the unit (“Local Project”) will be
fully functional, taking control of the hardware devices that are included
in it (MIMO4040DN, MIMO88, NXA units, etc.) and serving the UCP
panels it contains to potential UCP clients on the network
o
Disabled:
the EclerNet Local Project is deactivated, releasing the control
over all included hardware (MIMO4040DN, MIMO88, NXA units, etc. )
and, consequently, also ceasing to serve UCPs for clients
Warning:
In the disabled status, another device or computer running a
project containing all or some of the hardware devices existing in the
WPNETTOUCH's Local Project could take control of them.
Just one
device and project can take control of the same hardware device at the
same time
, so that units controlled by a device must first be released
before trying to control them from another device:
