6
Step1:
Please see PIC 2 and PIC 3. Line up the shafts and push the male connector pins into the
female connection. They will only fit together one way due to the special extrusions on the shaft
ends, one of which is slotted as shown in PIC3 and the other one which has a protrusion as shown
in PIC 2.
PIC.3 PIC.4 PIC.5
Step 2: Having fitted the two shafts together, slide the red outer sleeve attached to the handle shaft
down and over the red thread on the end of the trimmer head shaft. Please refer to PIC 4 and PIC 5.
Tighten the sleeve until both sections are fully and securely connected. There should be no
obvious movement once the sleeve is fully and correctly tightened. Please take care not to
cross-thread when connecting as this will cause damage and invalidate your guarantee.
V. OPERATION
Adjusting The Length Of The Telescopic Shaft
The Trimmer is packed with the telescopic shaft adjusted to it shortest position.
To begin with, release the shaft lock (please see page 2. Parts List - Part 6). Adjust the shaft
to desired position and then re-lock. See.Pic.1&2below)
PIC.1
PIC.2
Any questions or problems – please call the Eckman Helpline on 0871 590 5917 or go to
www.eckman.co.uk
