Firmware V1.4
20.05.2021
96/113
7.
1.
2.
3.
4.
SPECIAL CASE for systems in which up to a maximum of four WRG 3010 E are installed!
On request, the user will receive a separate "glt.cfg" from Eckelmann AG. This contains all data points for
the visualisation of the controllers.
In this case, the mask (see point 6) must be completed in full; the corresponding details will be provided
separately by Eckelmann AG.
9.2 Visualisation in LDSWin - WRG 3010 E
The "WRG 3010 E" visualisation page shows the schematic flow chart of the installation, with CO
2
and water
circuit. All actual values are visualised on this page and some setpoints can be adjusted here.
The following elements are available for the operation:
The setpoint for the speed control of the pumps. For HT and LT this is the spread in each case between flow
(red) and return (blue). When producing cold water, it is the switch-off temperature, which is also used to
monitor the inlet temperature of the water.
Setting the minimum and maximum speed of each pump.
For HT and NT the maximum permissible temperature in the flow and return, both can be set separately.
One button each to deactivate the HT and LT heat exchanger:
Button not activated: System component in function.
Button activated: System component in function - however, alarms are still active!
The pages can be moved and changed in their arrangement in LDSWin at any time as long as the
change mode is activated.
Practical tip:
If all pages have been completely imported, the change mode (see point 3)
must
be
deactivated again.