64 / 97
8.6.5
Starting of the program in the controller
Starting point: Program Editor is active, a program has been loaded into the controller
On principle, the operation of the CNC program is also possible without connected mechan-
ical system and drives. This is obtained by the setting of the machine constant
MK_TEST_OHNEMECHANIK=1
On principle, the operation of the CNC program is also possible without a PLC program. This
is obtained by the setting of the machine constant MK_SPS_DUMMY=1
During the tests with connected mechanical system and PLC, the machine constants have
to be set as follows:
Tabelle 37:
Table 37:
machine constants for test set-up
MK
Number values
Values
Test set-up
MK_TEST_OHNEMECHANIK
1
0
MK_SPS_DUMMY
1
0
Tabelle 38:
Table 38:
Starting of the program in the controller
Steps in stdHMI
Description
Automatic F10
Change the mode of StdHMI to Automatic
Start S1
Start drives, the figure is followed with activated graphics
(without activated graphics, the numbers of command and
actual positions change), the single commands are dis-
played in the lower part of the screen
Ov/- S6, S7
The path speed of the drives can be changed by means of
Override
Stop S2
The drives stop
Note: The drawn straight line from the zero point (0/0) to the starting point (10/10) is only
followed if the drive is also in the zero point. Otherwise, the controller moves the drives on
a straight line from the current point to the starting point.
