ECI MOVFR-LCD Installation Manual
Electronic Controls, Inc.
7073 North Atlantic Ave. Cape Canaveral, FL 32920
800-633-9788
P a g e
|
22
7
Initial Power Up and Test
7.1
Manual Operation
•
With the doors in the fully closed position and the AUTO/MAN switch in the MAN position,
apply power to door operator
o
LCD Display should show
o
Check that the POWER on the display board and PWR LED on the drive board are lit.
o
Check that the COM, and BRAKE LEDs on the drive board are lit.
•
Press Enter Button to select EDIT PARAMETERS
•
Press
–
button until INPUT VOLTAGE is highlighted.
•
Press ENTER button and set to proper input voltage using + button. Press ENTER then ESC
buttons when complete.
•
Move curser down to DIAGNOSTICS 1 and press ENTER
o
LCD should show
NOTE that the VBUS and TEMPs are estimates
•
With the AUTO/MAN switch in MAN position set the CLOSE/OPEN switch to the OPEN
position. (If motor moves in wrong direction, remove power from unit and swap 2 or the 3 motor
leads.)
o
The SPEED and MOTOR readings should increase as the door moves.
o
Hold switch until door is fully open and the DOL LED lights.
ECI MOVFR
(C) 2016 ECI Inc.
Edit parameters
Load defaults
Diagnostics 1
Diagnostics 2
ECI MOVFR
(C) 2016 ECI Inc.
VBUS : 317V 0s
SPEED : 0
TEMP : 29C/ 84F
MOTOR : .0A
CYCLE : xxxx (ESC)
