email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
Installation Guide
1
Installation Guide
Factory Connect Camera System:
Toyota
All Models equipped with 6.1” Screen
FC-TOYO
1
2
3
4
5
6
Remove radio / multi-media assembly.
Unplug factory 16 pin plug and plug into female
end of T-Harness. Plug male end of harness into
rear of radio. Connect camera RCA cable to
T-Harness.
A. Connect camera Red wire to suitable
ACC or IGN +12V. Ground camera Black
wire.
Use foam gasket to determine camera
mounting location. Drill a 19mm hole, mount
camera and secure with nut.
Connect the camera cable to the camera.
Program optional Parking Lines and/or
Image Flip.
Check installation by putting vehicle in reverse to
make sure image is correct. Reassemble all parts
of the vehicle to complete installation.
EXISTING
PLUG
16 PIN
CONNECTOR
Camera Cable
GND
+12V
ACC/IGN
B. Route camera cable to rear of vehicle.
Green Wire (Parking Lines)
White Wire (Image Flip)
NOTES:
Camera must be connected to ACC
or IGN not reverse trigger.
