OPERATION
DPPT-2600H
30
X7508310101
© 01/24 ECHO Incorporated
OPERATION
Lubricating the Guide Bar and Saw Chain
Automatic Oiling System
To prevent plastic deterioration, do not use synthetic or silicone
based oil.
1.
Wipe debris from around oil fill
cap.
2.
Remove oil fill cap and fill
reservoir with a quality, low
viscosity guide bar and saw
chain oil.
Adjusting Automatic Oiler
1.
From bottom of gear case, turn
adjustment screw (A) clockwise
to decrease oil volume, or
counterclockwise to increase oil
volume.
Note: The automatic oiler is
preset to deliver a
sufficient oil discharge
volume during normal
operating conditions.
During heavy or dry
cutting conditions, the oil
discharge volume may be
increased to assure
adequate lubrication. If oil
is leaking from the bar cover area, reduce the oil discharge
volume. Refill the oil reservoir with each tank of fuel.
Note: Very little visible oil on the saw chain will provide sufficient
lubrication.
A
A
