10
5 INCH CHIPPER/SHREDDER/BLOWER
FEATURES & CONTROLS
1. CHUTE EXTENSION TRAY
The feed chute has an extension tray that folds down. Raise the extension tray to an upright position and secure
with latch before towing the machine.
2. DISCHARGE CAP
Directs the discharge of material vertically. Adjust the discharge cap by turning the knobs located on the side. Turn
knob counterclockwise to loosen discharge cap. Adjust to desired position. Turn knob clockwise to secure discharge
cap.
3. DISCHARGE TUBE
Directs the discharge of chipped material horizontally. The discharge tube can be rotated 360° horizontally by
removing the pin and rotating the discharge tube until the discharge faces the desired position. Replace the pin in
one of the holes on the base of the discharge.
4. KNIFE ACCESS COVER
The knife access cover is used to access the shredder knives and chipper blades in order to check them or remove
them for sharpening.
5. ROTOR LOCK
Use the rotor lock to hold the rotor in place when doing any maintenance work. See Section 5.2.
6. CHIPPER CHUTE
Feed branches no larger than 5 inches (12.5 cm) in diameter into the chipper chute
7. SHREDDER CHUTE
Feed sticks and branches no larger than 3/4 inch (2 cm) in diameter into the shredder chute.
8. JACK STAND
Always have the jack stand retracted from the ground when moving the unit. When in use, be sure the jack stand is
down and locked in position with the snap pin.
9. SAFETY CHAINS
Safety chains are used, during towing, to prevent the chipper from completely separating from the tow vehicle in the
event the chipper detaches from the tow vehicle. Cross the safety chains under the hitch and connect to tow vehicle.
10. COUPLER
2 inch coupler for non-CE compliant models. 50 mm coupler for CE compliant models. Always use safety chains
when towing.
11. FUEL TANK
Fuel level indicator is located on top.
12. BELT GUARD
Remove the belt guard to access the drive belt. Never remove shields when in use.
13. SAFETY SWITCH
This machine is equipped with a engine kill safety switch that prevents the the engine from starting unless the knife
access cover is closed.
14. SHREDDER ADJUSTER
Move the shredder adjuster lever up to produce smaller sized shredded material. Move the shredder adjuster lever
down to produce larger sized shredded material.
