![background image](http://html1.mh-extra.com/html/ecg/zs-1420/zs-1420_instruction-manual_3897183045.webp)
44
45
attachment set to the longest cut, then use gradually shorter cut
lengths later during cutting.
Switch the device on by turning the
power switch to ON.
Before first cutting, turn on the trimmer by
moving the switch to the ON position to make sure the machine is
operating normally and the blades move smoothly.
Setting the cut length (see fig. 2)
The trimmer can be used without the comb attachment for
a minimum length cut. To completely remove the comb attachment,
press gently on the attachment from the rear of the device until
it is released from the lock. To adjust the length of the cut on the
attachment, turn the knob no. 3 clockwise or counterclockwise to
the mark on the trimmer body. For each setting level see the column
„A“ , for corresponding length of the cut in mm see the column „B“ in
the table Cut length setting.
Beard trimming
Before trimming, make sure the beard is clean and dry.
Cut the beard in the direction of growth.
NOTE: Always turn off the trimmer during breaks in cutting.
CLEANING AND MAINTENANCE
Turn off the device.
Remove the removable comb attachment and
rinse it with water. Before reassembly, allow it to dry thoroughly.
To clean the cutting head with the blades, use the supplied cleaning
brush.
Never clean the head with blades with water or other fluid.
We recommend gently lubricating the moving teeth of the cutting
edges with silicone oil after each use.
You can use the supplied oil.
Use only acid free oil.
DO NOT USE vegetable oils, fat or oils with
solvents for lubrication. The solvents evaporate and leave a strong
layer of grease that can slow the movement of the blades.
Gently
press the bottom of the blades to open the head and lubricate the
moving parts of the mechanism.
Remove the excess lubricant with
a dry, lint-free cloth.