![background image](http://html1.mh-extra.com/html/ecg/pcb-728-s/pcb-728-s_operating-manual_3872498091.webp)
EN
90
SAFETY INSTRUCTIONS
READ CAREFULLY AND STORE FOR FUTURE USE!
Warning:
The safety steps and instructions in this user's manual do not include all the possible
conditions and situations which may arise. The user must understand that a factor that cannot be
built into any product is common sense, caution and care. These factors must therefore come from
the user/s using and operating this product. We do not take responsibility for damages caused during
transport, by incorrect use, by voltage fl uctuations or a change or modifi cation of any part of the
product.
To prevent the danger of a fi re occurring or injury by electric shock, basic provisions should be adhered
to when using electric products, including the following:
1.
Make sure that the voltage in your power socket corresponds to the voltage on the product's label
and that the power socket is properly earthed. The power socket must be installed according to
valid safety regulations.
2.
Do not use the breadmaker i f the power cord is damaged. Have all repairs including power cord
replacement done in an authorised service! Do not remove protective covers from the product
as there exists a danger of injury by electric shock!
3.
To avoid potential injury by electric shock, protect the product from direct contact with water
and other liquids.
4.
The breadmaker should not be left in operation without supervision.
5.
Do not use the breadmaker to heat the room!
6.
It is recommended to monitor the product when baking an untested recipe!
7.
Never submerge the breadmaker under water (even partially)!
8.
Pay careful attention when handling the product to avoid injury, (e.g. burns, scalding). While
baking steam comes out of the ventilation openings and the surface of the breadmaker is hot.
9.
If smoke comes out of the breadmaker caused by the combustion of the prepared ingredients,
leave the lid closed and immediately disconnect the breadmaker from the power grid.
10. We recommend that you do not leave the breadmaker with the power cord inserted in the
power socket without supervision. Before carrying out maintenance pull the power cord out of
the power socket. Do not pull the plug out of the power socket by pulling on the cord. Pull the
cord out of the power socket by holding the power plug.
11. Do not use the breadmaker outdoors or in a wet environment. Do not touch the power cord of
the breadmaker with wet hands. There is a danger of injury by electric shock.
12. Pay extra attention if using the breadmaker near children.
13. The power cord must not touch any hot parts or go over sharp edges. Do not wind the power
cord around the product, this will prolong its lifetime.
14. The surface temperature of the product may be higher than usual during operation. Place the
breadmaker away from other objects to ensure free circulation of air necessary for its proper
function.
15. Never cover the area between the wall of the breadmaker and the baking container and do not
insert any objects into this area (e.g.: fi ngers, spoons, etc.). The area between the wall of the
breadmaker and the baking container must be free.
16. During operation and afterwards, do not touch the baking areas or hot parts of the product until
the product cools down. Only touch the handle so as to prevent burns.
17. The baking surfaces of this product have a non-stick surface so they are easy to clean. Do not use
any metal or other hard objects or utensils for cleaning or handling the inside/outside parts of
the product or to handle the bread, this is to prevent the baking surface from being damaged.
18. Do not place the breadmaker on a hot surface or use it near a heat source (e.g. hot plates).
19. This product may not be used by any persons (including children) with mental disabilities, weak
strength or by inexperienced persons, unless they have been properly trained or schooled in