![background image](http://html.mh-extra.com/html/ecg/nz-201/nz-201_instruction-manual_531099025.webp)
GB
25
IRONING AND STEAMING
Spraying
Press the sprinkling button to dampen hard to remove creases. Make sure there is enough water in the tank.
Ironing without steam
To use as a dry iron, set the steam control to the steam off position and set the temperature according to the
type of fabric.
Ironing with steam
Set the temperature control to ••• or MAX and the steam control to the steam out off position. As soon as the
heating indicator switches off, set the steam control to the desired value. Steam will begin to emit from the iron
plate, you may now begin to iron.
Ironing with the steam burst
Press the burst button to iron hard to remove creases with a strong steam spray.
For fine fabrics, we recommend moistening the fabric or to inserting a damp cloth between the fabric and iron
before using the burst function.
Vertical steam burst
Hold the iron in an upright position and hold the spray button down to iron and straighten creased drapes,
curtains, clothes etc. Wait a few seconds before pressing again. The burst function is only available at high
temperatures. Stop using the burst function as soon as the soleplate temperature indicator lights up. Continue
ironing only after the indicator light goes out.
Attention:
Never direct the steam at persons or animals.
OTHER FUNCTIONS
ANTI-CALC system
The anti-calc feature filters minerals contained in the water and prevents them from settling in the steam
chamber.
ANTI-DRIP system
Iron steam output stops automatically in case of too low temperature to prevent leakage of water from the
soleplate at too low temperature.
Iron may cool to a temperature at which steam has stopped, but the boiling water drops could cause stains on
the laundry. In these cases, the iron automatically activates the anti-drip water system so you can iron the finest
fabrics without the risk of damage or staining.
Self-cleaning mode
Attention:
Perform the procedure above a sink or other suitable area.
Fill the iron water container with water to the maximum mark, turn the iron on and set the temperature control
to maximum temperature position. After about 3 minutes press and hold for 1 minute the automatic cleaning
button. The steam chamber will be cleaned with a flow of steam and hot water. We recommend repeating this
procedure every 14 days.
CLEANING, MAINTENANCE AND STORAGE
After you have finished using the iron, open the nozzle lid, pour out the remaining water, set the steam control
to minimum and the temperature control to minimum. Always make sure the steam iron is completely cooled,
clean and dry before putting it away. Store the iron in an upright position.
Summary of Contents for NZ 201
Page 39: ......