![background image](http://html1.mh-extra.com/html/ecg/ewf-1280-ida/ewf-1280-ida_instruction-manual_3966957088.webp)
GB
88
Problem
Possible cause
Troubleshooting
Unsatisfactory washing
results.
Your laundry was too soiled for the
selected program.
Select suitable program (see Program
table).
Insuffi
cient amount of detergent.
Use more laundry detergent.
Load size exceeds the maximum
capacity of your washing machine.
Do not exceed the maximum load
capacity of your washing machine.
The water may be too hard.
Dispense the detergent in accordance
with the recommendation of the
detergent manufacturer.
Uneven distribution of the laundry
in the washing machine.
Distribute the laundry in the washing
machine evenly.
The water is discharged
immediately after fi lling.
The end of the drain hose is too
low.
Place the drain hose in correct height
(**).
There is no water visible
during washing in the
drum.
This is not a malfunction. The water
is in the bottom part of the drum.
There is detergent residue
on the laundry.
Undissolved powder residues in the
form of white dots may appear on
the clothing.
Rinse the laundry again using the
“Rinse” or after drying the laundry,
clean the spots from clothing using
a brush.
There are gray spots on the
laundry.
These stains may be caused by oil,
cream or ointment.
The next time you wash, use the
maximum amount of detergent
recommended by the detergent
manufacturer.
The spin did not start or
started belatedly.
This is not a malfunction. The
control system of even distribution
of laundry was activated.
The control system tries to achieve
a more even distribution of laundry.
The spin starts after rearranging the
laundry. The next time you wash, load
the laundry evenly.
Can not open the door of
the washing machine.
The water temperature is too high.
Wait until the water cools down.
There was power outage.
Check the power status.
There is a smell.
With a new washing machine, smell
of rubber sealing may be smelt
after heating during operation.
This is not a malfunction.
(*) See section on maintenance and cleaning of the washing machine.
(**) See section on installation of the washing machine.
Emergency door opening
If you need to open the door, e.g. in the event of a malfunction, disconnect the washing machine from the
socket and wait for the drum to stop. Then pull the emergency washing machine rod located at the bottom
right of the washing machine. You will hear a slight click, then the door can be opened. Before opening, make
sure the water temperature is below 60°C.
EWF 1280 IDA+++_manual_cz_sk_de_en.indb 88
06.05.2019 17:41:42
Summary of Contents for EWF 1280 IDA+++
Page 2: ...EWF 1280 IDA _manual_cz_sk_de_en indb 2 06 05 2019 17 41 14...
Page 93: ...EWF 1280 IDA _manual_cz_sk_de_en indb 93 06 05 2019 17 41 43...
Page 94: ...EWF 1280 IDA _manual_cz_sk_de_en indb 94 06 05 2019 17 41 43...
Page 95: ...EWF 1280 IDA _manual_cz_sk_de_en indb 95 06 05 2019 17 41 43...