![background image](http://html1.mh-extra.com/html/ecg/edf-4525-qwa/edf-4525-qwa_instruction-manual_530972019.webp)
English
English
19
For 60 cm dishwashers
Programme
Information for program
selection
Program
description
Detergent
Pre-wash/wash
Program
length
(min.)
Energy
consumption
(kWh)
Water
consumption
(l)
90 min.
Light washing program
is suitable for delicate
dishes, sensitive to high
temperatures. (Start
immediately after using the
dishes)
Wash (50°C)
Rinse
Hot rinse
Drying
5/20 g
90
0.89
14
30 min.
Lightly and normally soiled
glasses, plates or bowls,
everyday washing.
Pre-wash
Wash (40 °C)
Hot rinse
15 g
30
0.50
7
Rinse
To rinse dishes, which you
want to wash later.
Pre-wash
–
11
0.01
4
* EN 50242: this program is a testing cycle.
Information for comparative test in accordance with EN 50242 is as follows:
•
Capacity: 12 sets for 60 cm dishwashers, 9 sets for 45 cm dishwashers
•
Upper basket position: Bottom position
•
Setting of rinse-aid dispenser: 5 (or 4 for dispenser with four positions)
Switching on the appliance
Starting the wash program
1. Fill both baskets with dishes and load them back.
We recommend that you fill first the lower basket and then the upper one (see chapter “Control panel“).
2. Add the detergent (see chapters on dosage).
3. Connect the power cord to a suitable power outlet, see rating plate of the appliance. Check, if the water
supply is fully open.
4. Make sure that nothing prevents the spray arms from moving and close the door.
5. Press the power switch and pressing the program button select the required washing cycle, see Program
table.
Note:
•
When you properly close the door you will hear a click. After completing the wash, you can turn off the
appliance by pressing the power button.
Changing program
Basic condition: You can change the program during the operation only in case that the dishwasher runs for
only a short time. Otherwise, the detergent may be already consumed and water is drained. Then you need to
refill the detergent dispenser again (see section “Adding detergent”).
1. Press the power button to cancel the program and when you press this button again, you turn the
dishwasher on.
2. Now you can select new required program (see “Starting the washing program”).
Note:
•
If you open the door during the washing cycle, the dishwasher stops, an alarm signal sounds and the
display shows error message “E1”. When you close the door, the dishwasher resumes washing after a short
pause.
Note:
•
If all the control lights start flashing, it means that the dishwasher is out of order. Turn off the main switch,
close the water supply and call service.