![background image](http://html1.mh-extra.com/html/ecg/ed-8026/ed-8026_instruction-manual_3870270035.webp)
GB
35
Preparation
1. Unfold the blanket on the bed and make sure it is not creased or folded.
2. You can spread over the blanket only a thin cotton bed sheet. Do not cover it with a blanket or other cloth
that could cause the blanket to overheat and reduce heat transfer.
3. Place the controller so that it could be easily accessible. Make sure it is not hidden under a blanket, pillow
or the like. Do not leave the controller near other heat sources to prevent its overheating and damage.
4. Make sure the cord is positioned so that no one trips over it.
Setting basic temperature:
1. Connect the power cord of the blanket in the electric outlet 220~240 V, 50/60 Hz. Move the switch on the
controller in the position [2]. The light comes on and the electric blanket starts to warm up. The heating
lasts about 30-60 minutes. You can then move the switch as needed in the position [1] for comfortable
warmth when falling asleep or in the position [0] for complete shut-off of the heating (the control light
goes off). If you want to use the blanket continually the whole night, move the controller in the position
[1].
2.
Dual control:
In the double bed version, two people can operate the blanket independently according to
their needs without affecting the settings.
3. If you will no longer use the blanket, turn it off to the "0" position and unplug it.
CLEANING AND MAINTENANCE
So that you use the heating blanket always safely, pay attention to the following instructions:
•
Check regularly that the blanket is not crumpled or wrinkled.
•
Prior to each use check the blanket for signs of wear or damage. Check the condition of the power cord
and plugs, controller and blanket itself. If you are unsure whether the condition of the appliance allows its
safe use, contact an authorized service center.
•
The heating conductor in the electric blanket should be evenly distributed, without crossing and layering.
Check by passing a hand over the blanket.
•
Do not allow children to jump on the bed with the spread electric blanket. If this has already happened,
check the blanket for damage.
•
In case of accident or damage (fire, burning by a cigarette, unusual sounds or smells) disconnect the
blanket from the power supply immediately.
Cleaning
Turn the control switch to the “0” position and disconnect it from the power supply before each cleaning. Let it
cool down and disconnect the controller. Never immerse the controller or the power cord in water. Be careful
not to get them wet during cleaning.
To clean the blanket, place it on a flat surface and wipe it with a soft, damp cloth with a mild detergent.
Do not use industrial solvents such as benzene, kerosene or similar solvents for cleaning.
The blanket can also be machine washed. However, this will reduce its life. Always disconnect the controller
before washing. We recommended to place it in a textile washing bag before washing. Use a small amount of
detergent and set the program to gentle washing with a maximum temperature of up to 40 °C.
Then allow the blanket to dry freely. Throw it over the clothes dryer or clothes lines. Do not use clothes pegs,
do not dry it in the sun.
Do not use hair dryers, etc. for drying, you could damage the blanket.
Do not try to speed up the drying by
plugging the blanket into the mains!
Do not clean the blanket chemically, do not bleach it, dry in the laundry dryer or iron it.
NOTICE: Before using it again or storing it make sure that the blanket is completely dry.
Storing
Store the unused electric blanket in a dry place, packed in the packaging in which you purchased it. Let the
blanket cool down thoroughly before storing it. To prevent damage, do not place heavy objects on the folded
blanket.
Summary of Contents for ED 8026
