![background image](http://html1.mh-extra.com/html/ecg/acr-5570/acr-5570_instruction-manual_3864502035.webp)
GB
35
Before putting the device into operation, make sure that the water tank is filled at least up to the "MIN"
mark and at the same time that the water level does not exceed the MAX mark. There is a risk of damage
to the product or injury.
Remote controller
Prior to use, a button battery (CR2032, 3 V)
included in the package must be inserted into
the remote controller. Open the cover and insert
the battery, see the picture. Keep proper polarity
of the battery. If the appliance is not used for long
periods, remove the battery from the remote
control.
If the battery is empty, replace it with a new one of the same type.
Note:
When using the controller, aim at the sensor located on the device.
If there are obstacles between the remote controller and the sensor, signal transmission may not occur.
On/Off
1. Once the appliance is plugged into a socket, all LED indicators light up for 2 seconds and an audible alert
sounds. Then the appliance enters a standby mode in which no buttons are operational except
ON/OFF
.
a. Press
ON/OFF
to turn on the appliance, signalled by a beep. The indicators flash briefly 5x and go out.
Thanks to the internal memory of the appliance, it will start operating in the same mode in which it
was switched off. Now the device can be controlled and adjusted using the other buttons, see the
chapter below.
b. If you press this button while the appliance is running, it will be switched off, which will be signaled by
a longer beep. When the appliance is switched off in humidification mode, the fan will run for about
10 seconds after switching off.
Buttons functions
ON/OFF
Use the ON/OFF button to switch the device on or off.
COOLING
Use the button COOLING to choose between modes
fan/cooling with humidification
.
In the mode
cooling with humidification
the pump is turned on and the air is cooled and humidified through
the water in the tank.
Cooling with humidification is indicated by the light on the instrument panel above the COOLING icon. When
you choose the mode „
fan
“, the indicator above the COOLING icon turns off.
If the water in the tank drops below the MIN level during humidification cooling, a warning signal sounds for
10 seconds and the unit automatically turns off this function.
Note:
If you press and hold this button for at least 3 seconds, you will override the air cleaner warning.
SPEED
Press the SPEED button to set the
air flow speed
. The indicators on the control panel above the button light
up according to the current speed mode (from left to right
low
->
medium
->
high
).
PULL
PRESS
Battery Installation