28
EN
6. Bass
Press
SEL
repeatedly until “BAS” appears on the display. Turn the
VOL
volume dial to adjust the bass.
7. Treble
Press
SEL
repeatedly until “TRE” appears on the display. Turn the
VOL
volume dial to adjust the treble.
8. Balance
left-right
Press
SEL
repeatedly until “BAL” appears on the display. Turn the
VOL
volume dial to adjust the balance
between left and right channels. “L=R” on the display indicates the balance is in the middle.
9. Fade
front-rear
Press
SEL
repeatedly until “FAD” appears on the display. Turn the
VOL
volume dial to adjust the balance
between front and rear channels. “F=R” on the display indicates the balance is in the middle.
10. Equalizer
Press
SEL
repeatedly until “EQ” appears on the display. Then choose from the selection of equalizer eff ects. The
following options are available: FLAT - ROCK - POP - CLASS.
11. Beep
Press
SEL
repeatedly until “BEEP” appears on the display. Turn the
VOL
volume dial and select “BEEP OFF” or
“BEEP ON”. When the feature is enabled (BEEP ON), a beep sound will emit each time a button is pressed.
12. Volume pre-set
Press and hold
SEL
for 2 seconds until “TA ALARM” is shown on the display. Press
SEL
repeatedly until “P-VOL”
appears on the display. Turn the
VOL
volume dial to adjust the volume that will be the default volume each
time the device starts.
13. Clock
Press and hold
CLK
, the time will appear on the display.
Press and hold the button until the time begins to fl ash. Turn the
VOL
volume dial to adjust the hour and press
SEL
to get the minutes fl ashing. Turn the
VOL
dial to adjust the minutes. Confi rm the settings by pressing
CLK
.
CONTROLLING THE STEREO
1. Radio bandwidth selection
Press
BND
to enter the radio receiver features at any time.
The system off ers 5 bands: three FM bands (FM1, FM2 and FM3) and two AM bands (AM1 and AM2). You can
store up to six pre-set stations in each of the fi ve bands. Up to 30 stations can therefore be stored in the system
memory.
2. Tune / Scan
In Radio mode, press “
>>|
” or “
|<<
” once, the radio frequency will move further or back by one step.
Press and hold “
>>|
” or “
|<<
” and the receiver will scan for the next/previous radio station with a strong signal.
Repeat to fi nd additional stations with a strong signal.
3. Switching between stereo and mono reception
In FM mode, press
SEL
repeatedly until “MONO” or “STEREO” appears on the display. Turn the
VOL
dial and
select the desired reception mode.
4. Storing pre-set stations
The system contains six buttons, which allow the user to directly tune stations stored in the memory. Up to 6
stations can be stored for each band. While listening to a radio station, to store the respective station as a pre-
set on your device, press and hold one of the buttons labelled
1
through
6
, until the pre-set number appears
on the display. The station is now stored under this button.
5. Auto-store / scanning through pre-sets
A:
Auto-scan and store
While listening to FM radio, press and hold
F/PS
for three seconds. The receiver will automatically scan through
the frequency band and store stations with the strongest signal into the system.
While listening to AM radio, press and hold
F/PS
for three seconds. The receiver will automatically scan through
the frequency band and store stations with the strongest signal into the system.
