![background image](http://html1.mh-extra.com/html/ecg/39-led-602-pvr/39-led-602-pvr_instruction-manual_3877430027.webp)
27
EN
WIRING DIAGRAM
Make sure the car bracket is properly grounded. Good grounding eliminates most problems with electrical
interference. Quality grounding requires a solid connection to the car bracket.
10 A fuse
RCA OUT
Left=White
Right=Red
Antenna
connector
Connector A
1. Speaker, back, right + (purple)
2. Speaker, back, right - (purple/black)
3. Speaker, front, right + (grey)
4. Speaker, front, right - (grey/black)
5. Speaker, front, left + (white)
6. Speaker, front, left - (white/black)
7. Speaker, back, left + (green)
8. Speaker, back, left - (green/black)
Connector B
1. Empty
2. Empty
3. Empty
4. Continuous power +12V (yellow)
5. Automatic antenna control (blue/white)
6. Empty
7. Boost converter (red)
8. Ground
(black)
Speaker wiring notes
•
Follow the diagram above when installing the car stereo with new or existing speakers.
•
The car stereo is designed to be used with four (4) speakers with an impedance between 4 to 8 Ohms.
•
A speaker impedance lower than 4 Ohms could damage the stereo.
•
Do not bridge or combine speaker wire outputs. If you are not using four speakers, use insulation take to
insulate the ends of unused speaker wires, to prevent short-circuits.
•
Do not connect the negative speaker terminal to the car bracket (ground).
BASIC CONTROLS
1. Power
On/Off
Press
POWER
to start the system. Press the button again to power off the system.
2. Mode
option
Press
MODE
to toggle between system modes.
3. Loudness
Press
SEL
repeatedly until “LOAD ON” or “LOAD OFF” is shown on the display. Turn the
VOL
dial to enable or
disable the feature. The feature is enabled with “LOAD ON” is displayed.
4. Mute
Press
MUTE
to deactivate the sound. Press the button again to reactivate sound.
5. Volume
Turn the
VOL
dial to adjust the volume. Turn the volume control dial clockwise to increase the volume, counter-
clockwise to lower the volume. A higher number indicates a higher volume.