25
EN
•
If an external power amplifi er is used together with this device, do not connect the orange wire to the
amplifi er power terminal. Do not connect the orange wire to the automatic antenna power terminal either.
This type of connection could result in excessive current consumption and serious damage. Detailed
information for connecting a power amplifi er and other systems can be found in the manual for the
respective system. These instructions shall be followed for the wiring installation.
•
Do not cover any air vents or the radiator panel. Risk of overheating and fi re.
•
Make sure the system is properly grounded to the car bracket. Good grounding eliminates most electrical
interference. Quality grounding requires a solid connection to the car bracket. The ground connection
point (car bracket) should be metal, cleaned of rust, paint, plastic or impurities, to ensure a good electrical
connection.
•
A choke may need installing into the power supply if there is apparent interference when you accelerate.
Leave this installation to a professional service shop.
•
When replacing a fuse, make sure to use a fuse with the same nominal value, as stated on the fuse socket.
Do not replace blown fuses with fuses of diff erent values. Seek professional help if you blow the fuse again.
•
Before connecting the battery and activating the system, carefully check all connections are correct.
•
After completing the installation and prior to using the device, connect the battery, then use a sharp
object to press the reset button (RES) to reset the device to default settings. After pressing the button, wait
a few seconds until the red light begins to fl ash.
Installation instructions:
•
Choose a location to install the system that will not interfere while driving.
•
Prior to fi nal installation, try connecting the cables to check that all is duly connected and the car stereo
and other systems work without any issues.
•
Only use components supplied with the system to ensure proper installation. Using unapproved
components can lead to defects.
•
Refer to your nearest dealer should the installation require drilling holes or other adjustments inside the
vehicle.
•
Install the system so that it does not interfere with the driver and that it cannot injure passengers should
the car come to a sudden stop, for example, in a critical situation.
•
Refrain from installing the system in places where it could be exposed to high temperatures, for example,
direct sunlight or hot air from the heating system, or in places exposed to dust, impurities or excessive
vibrations.
Remove the old device from the dashboard
Remove the exterior panel.
Insert the installation keys, supplied with the old system, into the
car stereo shaft along the side of the device (see illustration) until
you hear a click. Pull on the keys and pull-out your old system from
the dashboard.
Front assembly according to the DIN
standard
DO NOT DISCONNECT THE WIRING AT THIS TIME!
Mark the polarity of the speaker wires
Marking the polarity of the speaker wires will make connecting the existing speakers to your cr stereo easier.
Look over the wiring diagram before disconnecting the connectors of the old stereo. If you are not sure about
the polarity of the existing speaker wires, install new wires or refer to a professional service shop for help.
