Wiring Instructions:
Black Wire: Connect to (-) ground
Red Wire: Connect to a dedicated (+) power source with a customer
supplied inline fuse.
See wiring diagram in Figure 2 for details.
FIGURE 2
Installation:
For best results, select a mounting location between approximately
72” to 96”[1829 mm to 2438mm] from the ground. Once mounted,
angle the lighthead so the boundary line appears in the desired
location as shown in FIGURE 1.
1. Select a mounting location for the unit on a flat surface, and drill
a through hole (see below).
EW2015R, EW2025R, EW2030: 5/16” hole
EW2031R: 11/32” hole
2. Secure the light head with the supplied hardware.
3. Adjust the unit to face downward as shown and tighten the
screws located on each side of the worklamp.
FIGURE 1
Page 2 of 3
FIGURE 3
(+)
(-)
(+)
(-)
VEHICLE BODY
BLACK
GROUND
GROUND
LENS
IMAGE SHOWN:
EW2015R WIRING
APPLIES TO EW2015R,
EW2025R & EW2030R
MOUNTING POSITION
RED
VEHICLE BODY
BLACK
GROUND
GROUND
LENS
IMAGE SHOWN:
EW2031R
MOUNTING POSITION
RED
CUST
OMER SUPPLIED
IN-LINE FUSE
CUST
OMER SUPPLIED
IN-LINE FUSE
