Chengdu Ebyte Electronic Technology Co.,Ltd.
ME31-XAAX0440_UserManul_EN
Copyright ©2012–2021,Chengdu Ebyte Electronic Technology Co.,Ltd.
17
4.6.2 Device parameter display interface
The parameter setting interface from top to bottom is:
1. Local IP address (IP);
2. Subnet mask (Mask);
3. Gateway (GWIP);
4. Local port (Port);
5. Modbus address (Adress);
6. Baud rate (Baud);
7. Data bit (Data);
8. Stop bit (Stop);
9. Parity;
10. Language (Language);
11. Exit (Exit);
Among them, the data bit and the stop bit cannot be set. After the DHCP mode is turned on, the local IP address, gateway,
and subnet mask cannot be configured and are only assigned by the router;
4.6.3 Parameter configuration
On the information display page, press and hold the confirm button for 2 to 3 seconds to enter the parameter setting page;
Select the setting item, and after entering the parameter configuration page, short press the up and down keys to switch
the setting item;
Select the setting item, short press to confirm or right-click, the setting item acquisition cursor represents the selection
and enter the setting item;
Adjust parameter value: After selecting the setting item, the up and down keys can change the value or the optional value;
the left and right keys can move the cursor in the parameter item;
Confirm parameter value: After adjusting the parameter value, press the confirm key to exit the current setting item.
Save parameter settings and exit: After setting the parameters, move the cursor to the exit option and short press the
middle key to save the parameters and exit the parameter setting, or long press the middle key after determining the
parameter value in any parameter item to save the parameter and Exit the parameter setting.
