Chengdu Ebyte Electronic Technology Co.,Ltd.
E890-470LG12 User Manual
Copyright ©2012–2022
，
Chengdu Ebyte Electronic Technology Co.,Ltd.
1-3
1. Quick Start
To ensure that the product the user gets in the first place is qualified, here we provide a simple testing process for
the user to refer to throughout the process, while also allowing the customer to act as a quick start.
1.1. Preparation for start-up
Before working on the LORAWAN gateway, the user needs to prepare at least one PC, one network cable and
product supporting devices.
1.2. Hardware connections
Connect the WIFI antenna, and LoRa antenna, respectively, to the SMA connector under the device panel logo, as
shown above, before powering up the device (the power-up location is identified at the panel). After the above steps have
been completed, use the power supply that came with the device and then power up the gateway. Connect the computer
to the WIFI of the device (WIFI name E890-XXXX) and the WAN port of the device to Ethernet.
After power on, wait for about 1 minute or so, the WORK indicator on the panel is always on, which indicates that
the power on is complete, in addition, on the panel, the LoRa signal indicator and the indicator in the network properties
also start to work properly.
To ensure that the computer can access the WEB management interface via the LAN, the customer needs to ensure
that the computer's network properties are to automatically obtain an IP address, as well as to automatically obtain a DNS
server address, as shown in the figure below.
Summary of Contents for E890-470LG12
Page 1: ...Contents E890 470LG12 ...
