CC1310 Wireless Module
E70 Series User Manual
Copyright ©2012–2017, Chengdu Ebyte Electronic Technology Co., Ltd.
19
/
34
5.6.3 Configuration Procedure of Module
Only happened when power-on resetting or exiting sleep mode.
6.Operating Mode
The table below shows the status of corresponding modes:
Mode (0-7)
M2
M1
M0
Mode introduction
Remark
0 RSSI mode
0
0
0
UART
opens.
Wireless
closes
and
transmission is unavailable.
Module outputs RSSI value each
100ms through UART
1 Continuous mode
0
0
1
UART
opens.
Wireless
closes
and
continuous transparent transmission is
available.
Air data rate can be adjusted
automatically according to baud
rate. The baud rate must be same on
both receiver and transmitter. It is
applicable
for
high
speed
continuous data transmission.
2 Sub-package mode
0
1
0
UART
opens.
Wireless
closes
and
sub-package transparent transmission is
available.
Air data rate and baud rate can be
adjusted separately. It is applicable
for data packet transmission.
3 Configuration mode
0
1
1
UART
opens.
Wireless
closes
and
parameter can be configured.
Baud rate is fixed as 9600 8N1.
4 WOR mode
1
0
0
UART
opens.
Wireless
closes
and
subpackage transparent transmission is
available.
Receiving is not available under this
mode. Preamble code will be added
proactively before transmission to
wake up the receiver under mode 6.
5 Configuration mode (Same
as Mode 3)
1
0
1
-
-
6 Power saving mode
1
1
0
UART closes. Wireless works at WOR
power saving mode. Multiple time grades
can be configured.
Transmission is not available under
this mode. It can be woken up by
transmitter under mode 4 to achieve
low power consumption receiving.
7 Sleep mode
1
1
1
UART closes, wireless transmitting is
available and sleep mode is on.
It can be woken up by any falling
edge of M2, M1, M0.
