Ebyte E29-T Series, User Manual

Page: 12 / 31

Chengdu Ebyte Electronic Technology Co., Ltd. E29-400TXXX product data sheet
Copyright ©2012–2023
，
Chengdu Ebyte Electronic Technology Co.,Ltd. 12
5.3 Broadcasting Address

For Example: Set the address of module A to 0xFFFF and the channel to 0x04.

When module A is used as a transmitter (same mode, transparent transmission mode), all receiving modules under
the 0x04 channel can receive data to achieve the purpose of broadcasting.
5.4 Listening Address

For example: Set the address of module A as 0xFFFF, and the channel as 0x04;

When module A is the receiver, it can receive the data sent from all modules under channel 0x04, the purpose of
listening is realized.
5.5 Module Reset

After the module is powered on, AUX will immediately output low level, perform hardware self-check, and set the
working mode according to user parameters;

During this process, AUX keeps low level, and AUX outputs high level after completion, and starts to work
normally according to the working mode formed by M1 and M0; Therefore, the user needs to wait for the rising
edge of AUX as the starting point for the module to work normally.
5.6 AUX Description

AUX Pin can be used as indication for wireless TX &RX buffer and self-check.

It can indicate whether there is data not transmitted via wireless way, or whether the received data has not been sent
through UART, or whether the module is still in the process of self-check initialization.
5.6.1 Indication of UART Output

To wake up external MCU;