Copyright ©2012–2022
，
Chengdu Ebyte Electronic Technology Co.,Ltd
10
For example
：
0201061AFF4C000215FDAFDA50693A4E24FB1AFCFC6EB076478252775848F00
Advertising (Old ibeacon data format table)
iBeacon Prefix
UUID
Major
Minor
Tx-Power
6B
16B
2B
2B
1B
For example
：
1AFF4C000215FDAFDA50693A4E24FB1AFCFC6EB076478252775848F00
Note: From software version 7212-1-12 onwards, new ibeacon broadcast rules are enabled and default as the new version broadcasts.
Newly developed products are suggested to be parsed with the new version of broadcast. Older versions of broadcast will be
discontinued in the future. For compatibility reasons, we provide the "AT+IBCNVER" command to switch and query the ibeacon
broadcast version, see the AT command table for details.
5.6 Configuration
There are two configuration methods: serial port configuration and air configuration. The two configuration methods are basically the
same. Before the air configuration, the authentication password of AT+AUTH=123456 must be passed. After the authentication is
passed, the module is allowed to use the air configuration. The air configuration authentication cycle is this connection, and
re-authentication is required if the device is disconnected and reconnected.
The module is in configuration mode by default if it is not connected. And if the module is connected, you can enter the configuration
mode by sending "+++".
5.7 Data indication
When the module outputs data through the serial port, the module sets the DATA pin to low level, indicating that data is being
sent. AT command response does not change the DATA pin state.
5.8 UUID description
5.9 Status or event printing
Command AT+LOGMSG to enable the serial port printing function of status information. Status information
includes: connected, disconnected, wake up, and sleep. The format is as follows:
Service UUID
FFF0
（
configurable
）
characteristic value
UUID
property
description
SLAVE CHANNEL
FFF1
（
configurable
）
read / notify
The channel for the slave sending the data, and
the master receiving the data.
MAST CHANNEL
FFF2
（
configurable
）
read / write
The channel for the master sending the data
and the slave receiving the data.
CONFIG CHANNEL
FFF3
（
not
configurable
）
read / write / notify
Air configuration channel
